How to Volt Mod Your GF's vibrator!
I was getting complaints on how the batteries were always running low, and the tool was not provided the maximum amount of pleasure that it could. I also had complaints that it wasn't powreful enough. So instead of spending $150 on an expensive one for her, I improvised
* Take 1 generic run-of-the-mill vibrator (as shown):
http://img.photobucket.com/albums/v2...r/11052007.jpg
* Which has speed control for the shaft and the mini-fingers:
http://img.photobucket.com/albums/v2...1052007002.jpg
* You solder a wire to the start and the finish of the terminals:
http://img.photobucket.com/albums/v2...1052007003.jpg
* Wire it through the back and make a couple of nicks in the plastic to make room for the new wire:
http://img.photobucket.com/albums/v2...1052007004.jpg
* Job all neat at the back and completed:
http://img.photobucket.com/albums/v2...1052007005.jpg
* Be sure to leave plenty of cable length for the vibrator (5m is plenty), and perform the Power-On mod for a spare PSU you may have laying around.
http://img.photobucket.com/albums/v2...1052007006.jpg
* Plug the positive and negative in respectively into your corresponding molex pug.
http://img.photobucket.com/albums/v2...1052007007.jpg
==============
The job's all done. 1 PSU, 5 Meters of cable and a vibrator. Runs at 5v instead of 4.5, no longer slows down when both modes are switched to maximum, and NEVER runs out of batteries.
Enjoy!
-Mr Mordred
__________________
Add a +1 to the top of your post if you think this thread should stay and not be deleted!!!!
Bookmarks