cheers.i dont have the greatest of tools available but would i be correct in thinking if I just scrape away at the trace with a sharp knife until i reveal some copper, then the solder should take to it?Originally Posted by kyosen
cheers.i dont have the greatest of tools available but would i be correct in thinking if I just scrape away at the trace with a sharp knife until i reveal some copper, then the solder should take to it?Originally Posted by kyosen
> just scrape away at the trace with a sharp knife until i reveal some copper, > then the solder should take to it?
--
Yes, that's right!
See the attached picture, please.
Originally Posted by kyosen
ahh right i see scrape solder then cut a gap.cool.gonna continue tomorrow with it, buying a better soldering iron as this one is terrible especially at soldering a wire to a resistor.
Bookmarks