140mm Radiator/Grill Template

[cyclone3d]

The hole spacing for the fans is not correct on that template unless the radiator and fans have a custom spacing. I tried printing at 100% and fit to paper and both were the same. The fan holes on the template are probably 2-3mm further apart than they should be. I guess I could make it work but I would have to majorly wallow out the screw holes in order to be able to make it work.

I verified my fans are standard by test mounting one on my radiator.

The search continues for a working fan template for a 420mm radiator with 15mm spacing.

Ugghhh.. Setting the fans on this template and it is even worse than I originally thought unless I want about 7mm blocked of on each side of each fan. Not only are the screw holes all wrong (too far apart), but the radiator cutout is way too small. I'm guessing this template was never actually tested by the person who created it.

Maybe I will create an acurate one and post it up somewhere. Seems like after over a decade of people asking for a 3x140mm with 15mm hole spacing where the fans meet there would actually be one out there but I guess not.