ABIT AN8 Ultra Release 20 - Some options not working

[AgentGOD]

The following features seem to be not working at all:
-CPU Ref Voltage (Doesn't do anything)
-DDR Ref Voltage (Doesn't do anything)
-Idle Cycle Limit (Changing the value doesn't do anything, stays at 16 clks according to A64Tweaker)
-Dynamic Idle Cycle Counter (Disabling doesn't do anything)
-Read to Write Delay (Changing apparently doesn't do anything to the value)

These features don't work "properly":
-Max Async Latency (Actual value sets to the (set value - 2), ex: set to 10ns, it actually sets to 8ns, according to A64Tweaker)

Any chance of these being fixed?

[ColonelCain]

Maybe the Bios chip is faulty? Try going to release 19, only had problems with 20. For 20, everytime that I tried to get into the uGuru overclock utility, the board would freeze.

[AgentGOD]

Maybe the Bios chip is faulty? Try going to release 19, only had problems with 20. For 20, everytime that I tried to get into the uGuru overclock utility, the board would freeze.

So you are saying those options worked perfectly fine for you?

I'm on modded Release 20 (tictac & RebelsHaven). They never worked on any BIOS, as far as I'm aware of.

[halo112358]

the same options were broken on my board with rev20 - the RH/TicTac bios is broken also.

[AgentGOD]

That's what I thought. Now let's petition to give someone the incentive to fix them!

[AgentGOD]

*Bump*

[ColonelCain]

Oh, no, just version 20 never worked for me. Could you link me the modded v20?
Also, what does it have changed?

[AgentGOD]

Oh, no, just version 20 never worked for me. Could you link me the modded v20?
Also, what does it have changed?

http://www.lejabeach.com/ABIT/an8/abitan8bios.html

They added new memory dividers, and added the 200 MHz 15.6u tref and 16x R/W Queue Bypass tweak. Also a newer NVRAID software.